BVVQN - FRESH KOTE INTERIOR LATEX FLAT, 402143 (XII)

  • MSDS: BVVQN
  • Manufacturer: M A BRUDER AND SONS INC
  • Product Name: FRESH KOTE INTERIOR LATEX FLAT, 402143 (XII)
  • National Stock Number: 8010-00N053566
Product Identification

Product ID:FRESH KOTE INTERIOR LATEX FLAT, 402143 (XII)
MSDS Date:10/31/1992
FSC:8010
NIIN:00N053566
MSDS Number: BVVQN

Responsible Party
M A BRUDER & SONS INC
600 REED RD
BROOMALL, PA 19008
US

Emergency Phone: 215-353-5100;215-359-3635

Info Phone: 215-353-5100;215-359-3635

Cage: 85519

Contractor
M A BRUDER & SONS INC
600 BROOMALL, PA 19008 US

Telephone: 610-353-5100;610-359-3635

Cage: 85519

Ingredients

TITANIUM OXIDE (TITANIUM DIOXIDE)

Fraction By Weight: 1-10%

OSHA PEL N/K

ACGIH TLV: N/K


ETHYLENE GLYCOL

CAS: 107-21-1

RTECS: KW2975000

Fraction By Weight: 1-10%

ACGIH TLV: 50 PPM, VAPOR, C

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB


DIATOMACEOUS EARTH, FLUX-CALCINED; (DIATOMACEOUS EARTH)

CAS: 68855-54-9

Fraction By Weight: 1-10%

OSHA PEL N/K

ACGIH TLV: N/K


CLAY (KAOLIN); (ANHYDROUS ALUMINUM SILICATE)

CAS: 1332-58-7

Fraction By Weight: 11-30%

OSHA PEL N/K

ACGIH TLV: N/K


WATER

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: >3%

OSHA PEL N/K

ACGIH TLV: N/K

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL:IRRIT OF RESP TRACT. PRLNGD
INHAL MAY LEAD TO MUCOUS MEMBRANE IRRIT, DROWSINESS, AND/OR
LIGHT-HEADEDNESS, HDCH, NAUS. SKIN:IRRIT OF SKIN. PROLONGED OR
REPEATED CONTACT CAN CAUSE DERM. EYE:IRRIT OF EYES. PRLNGD OR RPTD
CONTACT CAN CREATE BLURRED VISION, CORNEAL INJURY. INGEST:AMTS
INGESTED (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:INCIDENTAL TO CONSUMER AND INDUSTRIAL
HANDLING ARE NOT LIKELY TO CAUSE INJURY; HOWEVER, INGESTION OF
LARGER AMOUNTS COULD CAUSE SERIOUS INJURY.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE AND SUPPORT CONTINUED
BRTHG. HAVE TRAINED PERSON GIVE OXYGEN IF NEC. GET EMERGENCY MED
ATTN. SKIN:WASH OFF QUICKLY WITH PLENTY OF WATER, THEN SOAP AND
WATER; REMOVE CONTAM CLTHG. WASH CONTAM CLTHG BEFORE REUSE.
EYES:FLUSH IMMED W/LG AMTS OF WATER, ESPECIALLY UNDER LIDS, FOR AT
LEAST 15 MIN. OBTAIN EMERGENCY MED TREATMENT. INGEST:OBTAIN MED
TREATMENT IMMEDIATELY.

Fire Fighting

Flash Point:NON-FLAMMABLE
Extinguishing Media:DRY CHEMICAL OR FOAM
Fire Fighting Procedures:NIOSH/MSHA APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . NON-FLAMMABLE. WATER MAY BE USED TO COOL AND PROTECT
EXPOSED CONTAINERS.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY BURST IF EXPOSED TO
EXTREME HEAT OR FIRE.

Accidental Release

Spill Release Procedures:COLLECT IN CONTAINER FOR DISPOSAL, ACCORDING
TO HEALTH AND ENVIRONMENTAL REGULATIONS. CLEAN UP WITH WATER BEFORE
ALLOWING TO DRY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE BELOW 10 DEGREE F. KEEP FROM
FREEZING.
Other Precautions:DO NOT TAKE INTERNALLY. KEEP OUT OF REACH OF
CHILDREN.

Exposure Controls

Respiratory Protection:CONTROL ENVIRONMENTAL CONC BELOW APPLICABLE
STANDARDS. WHERE RESPIRATORY PROTECTION IS REQUIRED, USE ONLY
NIOSH/MSHA APPROVED RESPIRATORS IN ACCORDANCE WITH OSHA STANDARD 29
CFR 1910.134.
Ventilation:MAINTAIN ADEQUATE VENT TO ENSURE AIR ENTRY DURING
APPLICATION AND DRYING TO PREVENT BUILD-UP OF VAPORS.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKER GOGGLES .
Other Protective Equipment:EMERG EYE WASH AND DELUGE SHOWER WHICH MEETS
ANSI DESIGN CRITERIA . SKIN CREAM (IF NEEDED).
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

Boiling Pt:B.P. Text:>212F,>100C
Spec Gravity:1.31-1.46
Evaporation Rate & Reference:SLOWER THAN ETHYL ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:51-74

Stability

Stability Indicator/Materials to Avoid:YES
OXIDIZERS, ACIDS, BASES, AMINES
Stability Condition to Avoid:ELEVATED TEMP. CONTACT WITH OXIDIZING
AGENTS.
Hazardous Decomposition Products:IF INVOLVED IN FIRE (FROM OTHER
SOURCES) COULD CONCEIVABLY RESULT IN RELEASE OF CARBON DIOXIDE AND
CARBON MONOXIDE.

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, AND
FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.